Treadmills

The treadmill display does not turn on
Check that the power cord is properly plugged into the treadmill into a grounded outlet and that the switch is in the ON or I position. If the display still...
Wed, 7 Jul, 2021 at 2:41 PM
The treadmill is not responding
If your treadmill does not respond at all, check that the safety key is properly connected. Without the safety key you cannot set up or turn on the treadmil...
Wed, 7 Jul, 2021 at 2:40 PM
My treadmill does not run smoothly or is out of centre
Does the belt not run smoothly or do you hear something because the belt is out of centre?   Lubricate  It is recommended to lubricate the surface under t...
Wed, 7 Jul, 2021 at 2:27 PM
There is a message on the screen that I need to lubricate the treadmill
Do you get a message that you need to lubricate the running belt or do you see a 'grease icon' on your display? There are treadmills that keep tra...
Wed, 7 Jul, 2021 at 2:25 PM
I feel static shocks when I hold the treadmill
If you feel the treadmill giving off static electricity, check the following points. Do you use an earthed socket?  Flow Fitness recommends that all tre...
Wed, 7 Jul, 2021 at 2:23 PM
My treadmill squeaks when I walk or run
There is a folding mechanism under your treadmill. This ensures that you can place the treadmill up. This is located next to the gas spring (cylinder). If y...
Wed, 7 Jul, 2021 at 2:21 PM
The treadmill gives an error code
The treadmill can give an error from E1 to E9. If you have an E1, E2, E4 or E5 error code, you can first try a calibration. You will find these attached her...
Wed, 7 Jul, 2021 at 2:19 PM
The belt is skewed/starting to fray
If the treadmill belt becomes skewed or starts to fray, it is not centered on time. In these cases, the belt must first be realigned and then re-tensioned. ...
Wed, 7 Jul, 2021 at 1:46 PM
The heart rate gives an abnormal value
When measuring the heart rate via handles during your training, a deviating value often arises. This has to do with the fact that a heart rate measurement v...
Wed, 7 Jul, 2021 at 11:59 AM
DTM100i: Reconnect your remote controller
If the remote controller has no response or you change a new one,  the remote controller and walking device need to re-establish communication.   Remote c...
Wed, 7 Jul, 2021 at 11:55 AM